How to connect a battery in Series?

　　The positive terminal of the first battery is connected to the negative terminal of the second battery, the positive terminal of the second is connected to the negative of the third, etc. The voltage of the assembled battery is the sum of the battery voltages of the individual batteries. So the batteries are connected: + to - to + to - to + to -, etc. The capacity of the battery is unchanged.

　　How to connect a battery in Parallel?

　　The positive terminal of the first battery is connected to the positive terminal of the second battery, the positive terminal of the second is connected to the positive of the third, etc. and The negative terminal of the first battery is connected to the negative terminal of the second battery, the negative terminal of the second is connected to the negative of the third, etc. So the batteries are connected: + to + to + and - to - to -. In this configuration, the capacity is the sum of the capacities of the individual batteries and voltage is unchanged. For example, if you take 5 6V 10AH batteries and connect the batteries in series, you would end up with a battery array that is 30 Volts and 10AH. If you connect the batteries in parallel, you would end up with a battery array that is 6 Volts and 50AH. By the way, this is how ordinary auto batteries are made. 6 2volt cells are put in series to give 12v battery and the 6 cells are just enclosed in one case. Many ni-cad batteries are done the same way.

　　POWER SONIC蓄电池应用领域与分类:

　　◆免维护无须补液；<UPS不间断电源；

　　◆内阻小，大电流放电性能好；<消防备用电源；

　　◆适应温度广；<安全防护报警系统；

　　◆自放电小；<应急照明系统；

　　◆使用寿命长；<电力，邮电通信系统；

　　◆荷电出厂，使用方便；<电子仪器仪表；

　　◆安全防爆；<电动工具,电动玩具；

　　◆独特配方，深放电恢复性能好；<便携式电子设备；

　　◆无游离电解液，侧倒仍能使用；<摄影器材；

　　PS and PSH-Series General Purpose used for :

　　Emergency Lighting

　　Burglar/Fire Alarms

　　Data Centers

　　Solar and Alternative Energy

　　Portable Communications

　　Wind Turbines

　　Robotics

　　Remote Monitoring

　　Portable Video E

　　Portable Lighting

　　Photographic E

　　Scientific Instruments

　　Test and Measuring E

　　and much more...

　　PG-Long Life and PHR-High Rate Series used for :

　　Communication & Telecom Systems

　　UPS - Uninteruptible Power Supplies

　　Power Station Applications

　　Remote Area Power Generation

　　Remote Access Devices

　　Can I take a wheelchair, scooter or other e that is powered by a sealed AGM or Gel battery on a airplane or cruise ship?

　　Yes. There should be no problem, the battery is considered non-spillable, non-hazardous, since it is a absorbed glass mat design. These sealed lead acid valve regulated (VRLA) batteries are classified as "Battery, wet non-spillable, not subject to regulations" by DOT and IMO. By IATA they are classified as "Not restricted for air transport" and they are in compliance with IATA/ICAO special provision A67. For the gelled electrolyte batteries, they are classified as "Battery, wet, filled with acid, UN2794, Class 8". They can be legally shipped via air with special packaging etc.

　　How do I Jump Start my Battery using booster cables?

　　WARNING-BATTERIES PRODUCE EXPLOSIVE GASES. These instructions are designed to minimize the explosion hazard. Keep sparks, flames and cigarettes away from batteries at all times. Both batteries should be of the same voltage (6, 12, etc.).

　　SAFE BOOSTER CABLE OPERATION When jump starting, always wear proper eye protection and never lean over the battery. Do not jump start a damaged battery; inspect both batteries before connecting booster cables. Be sure vent caps are tight and level. Be sure that the vehicles are not touching and that both ignition switches are in the "OFF" position. Turn off all electrical e (radio, defroster, windshield wipers, lights, etc.)